squish

英 [skwɪʃ]

美 [skwɪʃ]

v.  (被)压坏，挤坏; 发吧唧声; 发吱嘎声

过去分词：squished　过去式：squished　现在分词：squishing　第三人称单数：squishes　

BNC.48495 / COCA.19433

牛津词典

verb

• （被）压坏，挤坏
  if sth soft squishes or is squished , it is crushed out of shape when it is pressed
• 发吧唧声；发吱嘎声
  to make a soft wet sucking sound

英英释义

noun

• the noise of soft mud being walked on

verb

• put (a liquid) into a container or another place by means of a squirting action
• walk through mud or mire
  1. We had to splosh across the wet meadow
  Synonym:squelchsplashsploshsloshslop

双语例句

• It shows that the squish flow velocity decreases and the reverse flow velocity increases as cylinder heat transfer and cylinder gas leakage increase.
  本文还导出了考虑散热和活塞环漏气影响的轴向挤流速度和逆喷速度的解析关系式，该式表明散热和活塞环漏气使轴向挤流速度减小，逆喷速度增加。
• An Investigation of the Squish Motion in a Diesel Engine by Means of Shallow Water Modeling Method
  用浅水模拟法研究柴油机中的挤流运动
• The reflected spray distributes at squish zone and concave zone of combustion chamber, big swirl of spray is obtained and expand to more domains.
  反射后的油束分布在燃烧室的挤流区和凹坑区，形成大的油束涡流，并向较大范围扩展。
• By comparison, straight wall chamber ( type A) is easy to be manufactured, has the lowest thermal stress and has obvious squish. Type A is the best combustion room choice.
  比较而言，直壁ω型燃烧室最易制造，热应力较小，挤流作用明显，为最佳燃烧室方案。
• Reversed squish is mainly concentrated at edge of combustion chamber bowl.
  反喷或逆挤流主要集中在燃烧室边缘上。
• During the compression stroke the turbulence kinetic energy decreases due to the dissipation effect, while the turbulence kinetic energy in the center of the cylinder increases as a result of the squish effect.
  缸内平均湍动能强度在进气冲程中总体呈先增大后减小的趋势，压缩冲程中耗散作用使湍动能降低，但挤流作用使气缸中部的湍动能升高；
• Squish the ellipse to about half the size.
  挤椭圆约一半大小。
• In fact, if Christ himself stood in my way, I like Nietzche, would not hesitate to squish him like a worm.
  实际上，就算是耶稣基督本人挡住了我的路，我也会和尼采一样，毫不犹豫地像踩死一只虫子一样击倒他。
• You may have to squish it a little in one or more directions to break it loose.
  您可能口都得它在一个或多个方向的一点打破它松散。
• Valves are clustered near the center of the bore to minimize combustion chamber volume and to provide ample squish area.
  阀门是聚集在附近的孔中心，以尽量减少燃烧室量，以及提供足够的果酱领域。